The design and structural analysis of the endoprosthesis of the shoulder joint
ITM Web Conf., 15 (2017) 07015
Published online: 2017-12-15
Articles citing this article
The Citing articles tool gives a list of articles citing the current article.
The citing articles come from EDP Sciences database, as well as other publishers participating in CrossRef Cited-by Linking Program. You can set up your personal account to receive an email alert each time this article is cited by a new article (see the menu on the right-hand side of the abstract page).
Cited article:
This article has been cited by the following article(s):
Application of 3D Printing in Bone Grafts
Adam Brachet, Aleksandra Bełżek, Daria Furtak, et al.Cells 12 (6) 859 (2023)
https://doi.org/10.3390/cells12060859
Low-Cost Cranioplasty—A Systematic Review of 3D Printing in Medicine
Wojciech Czyżewski, Jakub Jachimczyk, Zofia Hoffman, Michał Szymoniuk, Jakub Litak, Marcin Maciejewski, Krzysztof Kura, Radosław Rola and Kamil TorresMaterials 15 (14) 4731 (2022)
https://doi.org/10.3390/ma15144731
Novel Microwave-Assisted Method of Y2Ti2O7 Powder Synthesis
Vladimir Chishkala, Serhiy Lytovchenko, Bohdan Mazilin, Edwin Gevorkyan, Vladimir Shkuropatenko, Viktor Voyevodin, Mirosław Rucki, Zbigniew Siemiątkowski, Jonas Matijošius, Agnieszka Dudziak, Jacek Caban and Artūras KilikevičiusMaterials 13 (24) 5621 (2020)
https://doi.org/10.3390/ma13245621
The influence of the nucleus pulposus on the stress distribution in the natural and prosthetic intervertebral disc
Robert Karpiński, Łukasz Jaworski, Józef Jonak, et al.MATEC Web of Conferences 252 07006 (2019)
https://doi.org/10.1051/matecconf/201925207006
Numerical analysis of spinal stabiliser in spondylolisthesis treatment with pedicle screws
Jarosław Zubrzycki, M. Kulisz, M. Szala, et al.MATEC Web of Conferences 252 08006 (2019)
https://doi.org/10.1051/matecconf/201925208006
FEM 3D analysis of rock cone failure range during pull-out of undercut anchors
J Jonak and M SiegmundIOP Conference Series: Materials Science and Engineering 710 (1) 012046 (2019)
https://doi.org/10.1088/1757-899X/710/1/012046
Stress distribution in the knee joint in relation to tibiofemoral angle using the finite element method
Robert Karpiński, Łukasz Jaworski, Józef Jonak, et al.MATEC Web of Conferences 252 07007 (2019)
https://doi.org/10.1051/matecconf/201925207007