ITM Web Conf.
Volume 15, 2017II International Conference of Computational Methods in Engineering Science (CMES’17)
|Number of page(s)||4|
|Section||Material Properties And Structure Research Methods|
|Published online||15 December 2017|
Analysis of fracture roughness parameters of S355J2 steel and EN AW-2017A-T4 aluminium alloy
Opole University of Technology, Faculty of Production Engineering and Logistics, Sosnkowskiego 31, 45-272 Opole, poland
* Corresponding author: email@example.com
This article presents an analysis of fracture surface for steel S355J2 and EN AW-2017A-T4 aluminium subjected to fatigue bending, torsion, and bending with torsion. Fracture surfaces were observed using the focus variation microscope, which allows for the acquisition of data sets with large depth of focus. The authors focus on presenting the features of profile roughness parameters on the example of differences between fracture propagation and rupture areas. The researchers are looking for a correlation or ratio between different profile roughness parameters, especially arithmetical mean deviations of the roughness profile Ra and maximum height of the roughness profile Rz, for this case.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.