ITM Web Conf.
Volume 17, 20184th Annual International Conference on Wireless Communication and Sensor Network (WCSN 2017)
|Number of page(s)||8|
|Section||Session 1: Wireless Communication|
|Published online||02 February 2018|
Digitized Modeling and Machining Simulation of Equal Base Bevel Gear
School of Mechatronics Engineering, Henan University of Science and Technology, Luoyang 471003, China
* Corresponding author: firstname.lastname@example.org
In order to achieve the NC machining to the equal base circle bevel gear with a standard cutter, to plan the machining path efficiently and to predict machining interference, based on the equal base circle bevel gear theory, the machining coordinate system for the bevel gear was established, according to gear tooth surface equations of the bevel gears, the tooth surface discretization function was derived, and through the calculation and get the discrete points, the gear surface was modeled in the software UG, and then the planning of the machining path, automatic programming and simulation processing were done. At last, simulation processing, analysis and comparison to the gear surface were carried on with the software VERICUT, improved that the gear surface modeling and NC machining methods were correct and feasible.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.